ESP32 LOLIN32 Lite MicroPython version with Battery Charger

CAD 8.90

FREE Domestic Shipping >75 CAD Cart Value 
FREE Shipping to US >100 CAD Cart Value
Information about shipping times and options
HERE

18 in stock

Buy at least 2 for CAD 8.01
Buy at least 6 for CAD 7.12
Buy at least 11 for CAD 6.23

Description

This ESP32 based WEMOS Lolin32 Lite compatible WiFi enabled Development Board comes with MicroPython Firmware (Interpreter) installed. All you need to program it, is a USB or serial (RX/TX) connection to the host (computer) and a terminal program. Programming is a lot simpler than Arduino (based on C), and can be done without the need for a special development environment (like Arduino IDE or AVR Studio).

Specifications:
Power Supply: 2.2V to 3.6V
Logic Level: 3.3V
Processors:
– Xtensa 32-bit LX6 core, operating at 160 or 240 MHz and performing at up to 600 DMIPS
– Ultra low power (ULP) co-processor
Memory:
– 520kB SRAM
– 4MB Flash
Wireless connectivity:
– Wi-Fi: 802.11 b/g/n
– Bluetooth: v4.2 BR/EDR and BLE Peripheral interfaces*:
– 12-bit SAR ADC up to 18 channels
– 2 8-bit DACs
– 10 touch sensors (capacitive sensing GPIOs)
– Temperature sensor
– 4 SPI
– 2 IS interfaces
– 2 IC interfaces
– 3 UART
– SD/SDIO/CE-ATA/MMC/eMMC host controller
– SDIO/SPI slave controller
– Ethernet MAC interface with dedicated DMA and IEEE 1588 Precision Time Protocol support
– CAN bus 2.0
– Infrared remote controller (TX/RX, up to 8 channels)
– Motor PWM
– LED PWM (up to 16 channels)
– Hall effect sensor
– Ultra low power analog pre-amplifier
Security:
– IEEE 802.11 standard security features all supported, including WFA, WPA/WPA2 and WAPI
– Secure boot
– Flash encryption
– 1024-bit OTP, up to 768-bit for customers
– Cryptographic hardware acceleration: AES, SHA-2, RSA, elliptic curve cryptography (ECC), random number generator (RNG)
Power management:
– Internal low-dropout regulator
– Individual power domain for RTC
– 5uA deep sleep current
– Wake up from GPIO interrupt, timer, ADC measurements, capacitive touch sensor interrupt

* – not all of the interface pins of the ESP32 module are accessible through the development board
* – this is a 3.3V device, make sure you use level shifter to connect I/O ports to higher logic level like 5V

WEMOS Lolin32 Lite official website

Additional information

Weight 0.02 kg
EAN

4260474033478

Manufacturer

UNIVERSAL-SOLDER or other

Brand

CANADUINO or other

Reviews

There are no reviews yet.

Be the first to review “ESP32 LOLIN32 Lite MicroPython version with Battery Charger”