STC-3008 is a Dual Temperature Controller with separate displays and Set-Points for both independent units.
Settings are stored even when power is interrupted.
– Temperature sensor NTC 10K, length 1m
– Measuring range -55 to 120°C
– Display resolution 0.1°C
– Sensor accuracy ±1°C
– Power supply 110-220VAC 50/60Hz
– Power consumption <3W
– Operating humidity (relative) 20 to 85%
– Relay outputs 10A/240VAC
The size of the front panel is about 75 x 34.5mm
The size of the base equals the front panel opening size and is about 70 x 28mm
The module is about 85.5mm deep (measured behind front panel)
Press and hold UP 1 button until the display flashes (about 3 seconds), then press UP 1 or DOWN 1 button to adjust the LOW (start) setpoint for the first unit.
Press and hold DOWN 1 button until the display flashes (about 3 seconds), then press UP 1 or DOWN 1 button to adjust the HIGH (end) setpoint for the first unit.
Do the same with buttons UP 2 and DOWN 2 for the 2nd unit.
To reset the controller to factory defaults, press and hold DOWN 1 and DOWN 2 buttons for about 3 seconds.